Screw on and tighten the nuts found on the left and right nipple. The plastic mounting nuts can sometimes be unscrewed by hand but metal mounting nuts will require the use of a wrench or slip joint pliers.
To remove the old faucet first unscrew the water lines and second unscrew the mounting nuts.
How to replace shower faucet in mobile home.
You will then need to get a good look at.
How to replace shower faucets in a mobile home step 1.
When replacing a shower faucet first block the shower drain with a cloth to prevent small parts from falling into the opening.
Snug but dont overtighten.
Attach the hot cold and shower lines.
To remove the handle pry off the small cover that hides the handle screw.
Locate the access panel in the wall behind your shower faucet and use a drill to remove.
Turn water on and check for leaks.
Use a screwdriver to take off the handle.
Remove the locking nut that holds the stem in using.
When the valve leaks it usually is just a couple o ringswashers that need replacing for a couple bucks.
Place a blanket or piece of cardboard on the floor of your tub or shower base to protect against dropped tools.
A handle puller may be required if.
First thing is shut off your water main.
Shut off the water before you begin.
Turn off the main water supply valve that brings water into the mobile home.
Next pop the plastic cover off the front of the knob and remove the philips screw.
Next remove the old faucet.
There should be no need to tear out the faucet to fix this.
Click here for information on replacing a mobile home bathtub.
If a leak exists you may need to then replace the rubber washers in the end of the waterlines or replace the end.
You will now need to clean behind the old faucet.
Cover your work area with plastic and a towel to catch any.
The knob should pull off.
No comments:
Post a Comment