Add glue to the outside finally add some superglue to the outside of the base of the eye. To fix a snapped fishing rod try using a fiberglass pole and some epoxy.
For more kayak fishing and rigging videos visit.
How to repair fishing rod eye.
Hold the new eyelet against the rod at the same spot where the old eyelet was connected.
How to fix an eye on a rod chris medlin.
How to repair a broken eye on a fishing rod.
Gently reheat the epoxy to soften it inset.
Smooth edges are stronger and less likely to break.
Push the new tip eye back onto the rod tip.
Slide one end of the pole into your fishing rod until there are 6 inches sticking out.
Instead of paying too much for shipping costs to send your rod somewhere to get the guide or entire rod replaced you can replace the guide at home easily and cost effectively.
Lightly scrape the exposed end of the rod with a razor blade to remove all traces of the old epoxy.
Pull off the eyelet and the thread that held it to the fishing rod.
Make sure the eye is lining up with the other eyes on the rod by looking along the rod.
While some anglers take their rods to a tackle shop for repair it is possible to repair broken rod eyelets at home.
First sand the snapped edges to make them flush.
Heat the end of an epoxy stick and apply the epoxy to the clean tip as you rotate the rod to ensure even coverage.
John toast oast from the temple fork outfitters and okuma pro staffs shows a quick and simple way to replace broken fishing rod guides and eyes.
How to repair a broken eye on a fishing rod.
Skip navigation sign in.
You can also use fine grit sandpaper to clean up the rod blank.
Cut a 12 inch long piece of fiberglass pole using a hacksaw.
No comments:
Post a Comment