Start by closing the toilet flapper valve on the water line to the toilet by turning it clockwise. Install the new gasket and valve.
Method 2 replacing your toilet flapper valve 1.
How to replace toilet flapper.
Take out any water left in the tank.
Drain as much water from the tank as you can.
Lastly reattach the chain to the handle arm.
Next unclip the lift chain from the flapper and remove the flapper by pulling it free from the pegs.
To put on a new hard plastic type flapper with closed loop arms slide one of the arms onto one of the pegs.
Get a towel and sponge and wipe up the rest.
Place the flapper on the flush valve and connect the hinges.
To replace a toilet flapper start by turning off the water supply and flushing the toilet to empty the tank so that you can access the flapper.
Turn off the water to the toilet by closing the shutoff valve located.
Turn off the water.
There are two hinges on the back of the flush valve.
Replacing a toilet flapper valve is a relatively simple fix that could save you a pretty penny on your water bill.
How to replace a toilet fill valve and flapper step 1.
Then flush the toilet and hold the flapper open to allow the water to drain from the tank.
Greg demonstrates how to remove the toilet flapper valve and shows the many kind of flapper models so that when you go to the hardware store to buy a replacement you can be sure to get the right one.
Remove the flapper from the package.
Remove the old flapper valve.
Diagnosing a flapper problem.
At this point it will become obvious if you have the correct flapper and chain for your toilet.
The kit contains a flapper and matching seat that you adhere to the damaged seat with the adhesive provided as shown.
When a toilet continues to run after you flush it.
Follow the included instructions to install the new toilet flapper valve seat and flapper.
A standard gravity flush toilet is remarkably simple in design.
Use a sponge to mop out the water that remains.
For a new hard plastic type flapper with open loop arms align the open loops with the posts and gently push down on the arms and snap the arms onto the posts.
First its worth noting that not all flapper designs are the same.
Loosen the nuts located on the base.
Begin the flapper valve replacement by removing the tanks lid turning off the water supply valve and flushing the toilet.
Once the tank is empty disconnect the lift chain from the flush lever.
How to replace a toilet flapper anatomy of a toilet.
Remove the water supply hose or tube.
No comments:
Post a Comment