You will hear a click at which point you will release the brake. Clearing the memory of fault codes.
Took my truck to the shop because the abs light is on they found a clevise pin missing on a front s cam and thought it was the problem it wasnt so they cleaned and checked sensors all was fine.
How to reset abs light on freightliner.
If necessary replace the fuse with another one of the same amperage.
These are the abs sensor wires.
Check that the metal strip inside the fuse is not damaged.
The abs light will stop flashing stay illuminated for one second then will flash four times to indicate you have cleared the light.
Sometimes its just dirt or rust particles on the exciter ring inside the drum.
When abs light wont go off most people are not aware that abs fuse is similar to any other electrical system.
It is protected by a fuse that may blow with time.
How to reset the abs warning light on a rover 800.
If then your abs light stays on below are the guideline involved to know how to reset abs light without scan tool.
Its not uncommon for the abs light to come on with many trucks.
Push and release the brake pedal eight times within three seconds.
Check the abs sensors at the wheels.
Press down on the brake pedal with your hand.
They said i need a abs brake module that cost 1300 and dealer will have to order it.
Behind the wheels on the brake rotor assembly there will be two wires running to the back of the brake rotor.
At first replace the faulty fuse.
If it stays on for more then a day or two then its probably a bad sensor or wire.
This video was taken after the faulty front abs sensor has been replaced see my other videos for what the.
No comments:
Post a Comment