They have to go back the same way. Crank the engine and check for a good spark at the spark tester gap.
Method 3 installing new wires.
How to replace spark plugs and wires.
Even though you cleaned around the spark plug thoroughly before beginning.
Once youve removed the first spark plug wire fit the necessary combination of extensions and swivels to the spark plug socket to comfortably fit the tool to the spark plug.
Attach a spark tester to the wire and to an engine ground.
Turn the spark plug counterclockwise until it comes free.
Since the spark plug wires stay installed for a long time boots installed without grease are almost impossible to remove.
How to replace spark plug wires method 1 preparing to replace.
And just like your plugs the wires wear out over time.
Using a wire puller twist the.
Connect the new wires in the same order as you removed.
Prop open the hood of your vehicle.
The air box contains your air filter and connects to the large intake plenum that you can see is hiding the rest of your spark plug wires.
Make sure that the car is turned off.
Spark plug wire replacement tip.
The heat literally welds them to the spark plug.
Replace only one spark plug wire at a time in the exact same spot on the distributor and to the same spark plug as the old wire.
You may even want to take a photo before you get started.
Remove a spark plug wire from any plug.
Replace them before that happens.
If your car was equipped with fine wire iridium spark plugs the center electrode on those plugs can be as small as 04 mm when new.
Method 2 removing the wires.
Once they begin to wear the electrical charge sent to the spark plugs can be unreliable which creates problems with engine operation including rough idling stalls and other issues.
A good spark will be blue white and will be plainly visible in daylight.
If you have a large flexible hose connecting the airbox to the plenum you can remove the clamps that hold the hose on each end.
Use your camera to record the route of each wire and spark plug.
When you change the spark plugs dont be shocked to see the center electrode worn down to the size of a pin.
If the spark plugs are connected improperly the vehicle wont perform as expected.
The first step is to remove the air box.
To remove spark plug wires from the plug without damaging the boot or wire use a spark plug boot puller tool instead of a pliers.
This is the job of your spark plug wires.
Worn spark plug wires and boots can start to leak voltage to nearby engine parts causing arcing and creating performance problems.
No comments:
Post a Comment