While the indicator light is blinking press the button on your remote. Test the new garage door remote by pressing once to see if the door moves.
If you have a remote that just has the button then you will need to do these steps to reprogram it.
How to reprogram garage door remote.
Place the ladder under the garage door power head and climb so you are within reach.
Within 30 seconds press hold the button on.
Press release the learn or smart button on the back of your garage door opener.
Press and hold the learn button on the side of the power head for approximately 10.
Locate the learn button on your opener in order to program your remote or keypad you will need to find the learn button on your garage door opener.
This button is either square or circular.
Use a ladder to reach the opener that is located in the middle of the garage.
You will see switches on the remote and the garage door opener.
If you want to program your garage door opener remote on your own here are the instructions for you to follow.
Push and release the learn button.
The learn indicator light will glow steadily for 30 seconds.
Remove the cover on your remote control.
To access the switches you may need to remove a control panel or cover.
To program a new remote into the system hold the learn button until the indicator light blinks on the opener.
How to reprogram a genie garage door remote step 1.
Step 3 program the remote.
The remote control on your garage door needs to be programmed properly to allow it to communicate with the main base unit.
Program your garage door remote control with help from a garage door.
In order for the garage door opener to function the pattern of switches must match on both the in garage motor and the handheld remote.
It is fairly simple and you can do it in about a minute.
In this video i teach you how to program or reprogram your craftsman garage door opener remote.
Hope this video helps.
No comments:
Post a Comment