How to replace garage door rollers instructions. How to replace the bottom garage door roller.
Dont try this yourself unless you have experience.
How to replace garage door rollers without bending track.
Next remove the track bolts and nuts that secure the track to the track brackets.
First open the door and mark the bottom of the track where it meets the garage floor.
Change the rollers on a garage door with help from a garage door specialist in this free video.
The rollers in your garage door allow the door to open and close smoothly.
Start by opening your garage door completely.
The rollers on a garage door will need to be changed periodically to keep the unit running properly.
3 minute bottom roller change on your garage door.
The safest way to replace the bottom roller is to bend the track so you can pop the bottom section out.
They will fall apart and you will be changing them.
Continue working on the rollers one at a time until youve replaced all but the top 2 rollers.
Dont buy home depot or walmart rollers.
Its easier than it sounds and it doesnt do any damage to the track itself.
There are normally two or three track brackets.
All the moving parts of a garage door need to be aligned for it to work properly.
Go to the other side of your garage door and bend the area of vertical track near the seam.
Place a clamp on to the track about 23 of the way up the door opening.
Pull the garage door so the roller lines up with the bent track and pop the roller out to replace it.
If you notice that the rollers have jumped the track immediately stop using the door until it can be repaired.
For safety it is best to replace the bottom roller on one side at a time.
The first thing youll want to do is open the door completely so you get full access to the track without the door getting in your way.
For added safety unplug the garage door opener from the outlet.
Release the garage door from the power opener by pulling on the attached release rope.
No comments:
Post a Comment