Turn off the water at the shutoff valve. Place the rubber spud washer with its beveled side out into the valve opening in the base of the tank.
Turn the valve that shuts off the water clockwise.
How to replace the inside of a toilet tank.
The flapper valve is the mechanism inside your toilet tank that controls the flush.
Remove the valve and float mechanism.
This video shows how i replaced the entire content inside the toilet water tank.
Carefully lift the toilet tank after you unscrew it.
Hold it firmly to prevent it from falling and place it on an even surface to discard appropriately once you complete the installation procedure.
Step 5 replace tank.
Fix toilet replace inside parts of toilet tutorial.
Discover this simple easy step by step method in plumbing how to change out a toilet tank inside parts part 1of 2 how to video.
Sponge out the remaining water or vacuum it up with a wetdry vacuum.
When you push on the handle the lever lifts a chain that in turn lifts the flapper valve.
Clean the bolt and nut with white vinegar and a small wire brush.
Replacing a fill valve requires only a few basic tools an adjustable pliers and a pair of scissors and an hour of your time.
Flush the toilet and hold the flush valve open to drain the tank.
Catch any drips.
Step 4 remove old tank.
Flush the toilet to.
Special thank to ctol1 for his help in this video.
If you arent replacing the spud washer reinstall bolts and nuts with new gaskets.
Remove the tank bolt with a screwdriver and adjustable wrench.
Unscrew the water supply hose from the bottom of the tank with your fingers or with pliers.
Alternate the tightening of the nuts to evenly draw the tank tight.
Fix toilet replace inside parts of toilet tutorial.
The valve covers an opening in the bottom of the tank that allows the water to flow down into the bowl and creates the flushing action.
This valve is on the wall or on the floor underneath the tank.
No comments:
Post a Comment