Gently lift up the shingles along the lower edge of the roof and find the nails attaching the eave strip to the roof decking. You can install a new fascia board in a couple of hours with the right tools to d.
Mount a ladder or scaffold.
How to replace fascia board with drip edge.
Slip the eave strip out from under the shingles.
Removing drip edge eave strips.
How would i take the drip edge off so i could replace the fascia board.
Change a rotten or damaged fascia board.
Pry up the metal spikes holding the gutter to the roof.
Use a flat pry bar and hammer to remove the nails holding the eave strip to the roof decking.
Replacing fascia board when the drip edge is nailed to it 1.
I need to get to the fascia board but my drip edge is covering it.
Place your nails in line with the marks on your drip edge and place it in the center of your fascia board.
It was very easy.
Drive 1 2 nails in per rafter so it doesnt move around.
Use 1 2 nails through each rafter to secure your fascia board.
I have a metal drip edge covering my fascia board.
Pry up with a cats paw or nail puller the nails in the drip edges bottom flange.
Pry the fascia board off the rafter ends and the sides of the.
Hold the board in place and use 2 in 51 cm nails and a hammer to secure it in place.
No comments:
Post a Comment